emcon_comm
Purpose:
- Communicate with an EMCON6 AVL Dyno system, allowing control and data to switch between the EMCON6 and CyFlex system.
Enter:
-
emcon_comm priority [s=/specfile] [i=ip_address] [p=port] [tcp | udp] [+c]
Where:
| priority |
Required. This specifies the priority of the task. |
| specfile |
Optional. Specify a specification filename. The default is /specs/emcon_specs. |
| ip_address |
Optional. Specify the IP address to communicate through. The default is 10.1.1.2. |
| port |
Optional. Specify the a port to communicate through. The default is 4753. |
| tcp | udp |
Optional. Specify whether to use TCP protocol or UDP protocol. The default is UDP. |
| +c | Optional. Specify this flag to indicate this is a critical task. This means the CyFlex watchdog will stop toggling if an issue occurs. |
Example:
- emcon_comm 20 &
The above uses the default specfile /specs/emcon_specs, default IP 10.1.1.2, default port 4753, using the UDP protocol, and has priority 20.
emcon_comm 20 s=/specs/ERIC_specs i=10.1.1.100 p=5478 tcp &
The above uses the specfile /specs/ERIC_specs, IP 10.1.1.100, port 5478, using the TCP protocol.
emcon_comm 20 +c &
This above uses the default specfile /specs/emcon_specs, default IP 10.1.1.2, default port 4753, using the UDP protocol. This task will also be monitored by the scheduler, and if this task dies, the watch_dog will die.
Notes:
- The ‘+c’ argument must be the final argument if it is used.