re-read

Purpose:

Send a RE-READ event message to an application whose specification file name matches the argument.

Enter:

re-read <reg_name>

Where:

reg_name

Specify the name that is the registered name of the target app and usually the specification filename used by that app. Note that the filename is NOT the full pathname. Use “sin names | grep <app>” to find the registered name.

Example:

re-read af_specs.101
The above command sets the ‘re-read’ event which would cause the gasfl application to re-read af_specs.101.

re-read CFS
The above command sets the ‘re-read’ event which would cause the cf_scales application to re-read the spec file passed as an argument during the initial cf_scales call.

Notes:

          The following programs accept the re-read event: 

              cf_scales

              lc_scales

              subsonic

              add_water

              volef and volef2

              cfv_1065

             gasfl

             gas_prop

             gas_mix

             gas_blend

             fa_total

             critical_flow

            alternator_torq

See Also: