take_fr
Purpose:
-
Take a Fuel Reading.
Enter
-
take_fr [fuel_weight]
Where:
-
fuel_weight
Optional. Specify the desired fuel weight value. The default is the smallest weight.
The ‘fuel_weight’ may also be expressed as a variable label, in which case, the value will be taken from that variable. The variable must have units of weight.
Example:
-
take_fr 3
The above command selects a 3 lb weight and takes one Fuel Reading.take_fr my_weight
The above command selects a weight which is equal to the value contained in the variable “my_weight”.
Notes:
-
The actual start of a fuel reading may be somewhat delayed, depending on the type of fuel measurement system used. For example, a scales system will have to wait until the balance is achieved before the reading actually starts.