take_frs
Purpose:
-
Take continuous Fuel Readings.
Enter:
-
take_frs [fuel_weight]
Where:
-
fuel_weight
Optional. Specify the desired fuel weight value. The default is the smallest weight.
Example:
-
take_frs 3
The above command selects a 3 lb weight and continuously takes Fuel Readings.
Notes:
-
This command requests that fuel readings be taken continuously. If a scales type fuel measurement device is being used, then the weight may be selected by the optional argument.
A Fuel Reading request precedes the start of an actual Fuel Reading, because the start is dependent on the fuel measurement device used.