pam_specs
Purpose:
-
This script processes the PAM Specs file /specs/pam_specs.N in two stages
Enter:
-
pam_specs
Where:
-
N/A
Example:
Notes:
- The PAMheader task is ran to create a new PAM Header file, using all entries in the Engine Specs file /specs/engine_specs.N.
- The “PAM_specs_cfg” event is set to signal the datapoint task to reload the $PAMDatapoint block in PAM Specs. Any changes are reflected in the next PAM Datapoint file.
- A check is performed to see if a fuel reading is in progress and if it exists.