star1.12
Purpose:
-
Create the star1 file based on the tri specs file and configuration.
Enter:
-
star1.12 <tri_specs=tri_specs_file> <star1_output=star1_output_file> <cfg=config_name> <em_bench=em_bemch_file> <cell_cfg=cell_config_file>
Where:
-
tri_specs
Specify the pathname of the tri spec file.
star1_output
Specify the pathname of the star1 output file.
cfg
Specify the name of configuration to use.
em_bench
Specify the pathname of the em_bench data file.
cell_cfg
Specify the pathname of the cell configuration file.
Example:
-
star1.12 ci_specs=/esvd_data/CTH_EUL/cvs_specs.dat
star1_output=/esvd_data/CTH_EUL/TorqueCurve320/star1.dat
map=TorqueCurve320
em_bench=/esvd_data/CTH_EUL/TorqueCurve320/1/em_bench.476363
cell_cfg=/esvd_data/specs/cell_cfg.dat
Notes:
-
– /e/’t’/ ‘cvs_specs.dat’ – /e/’t’/’m’/ ‘star1.dat’ – /e/’t’/’m’/’st’/ ’em_bench’.’r’ – /e/’s’/ ‘cell_cfg.dat’
where:
e esvd_data t test plan id st step number of the test r run number of the test c name of the cycle that was run s specifications that apply to all tests ‘ ‘ quoted string is a generic filename, later replaced by the actual filename when the script, ‘cvs_file_naming.10c’ is run. This is normally run from a script that generates the correct pathnames and files for the task.