dy
Purpose:
-
Set the dyno controller to open loop mode and specify a target value with an optional ramp rate.
Enter:
-
dy <target> [ramp_rate]
Where:
-
target
Specify the target value for the open loop dyno controller.
ramp_rate
Optional. Specify the rate at which the dyno controller should move from its current value to the new target.
Example:
-
dy 50
The above command puts the dyno controller in OPEN_LOOP mode and immediately sets the dyno command to 50%.dy 75 20
The above command puts the dyno controller in open loop mode and sets the target value to 75%.
The open loop dyno command will ramp from the current value to the target value at the rate of 20% per second.