cmd_map_gen

Generate control command map. The cmd_map_gen utility translates a breakpoint file to a command map file. The command maps section of Engine Controls explains this feature.

Enter:

cmd_map_gen <break_point_file> <command_map_file>

Where:

break_point_file	Specify the file containing breakpoint definitions which map a non-linear device.
command_map_file	Specify the file containing a command map, to be referenced in the control specifications.

Example:

cmd_map_gen throttle.brk throttle.map

The above command converts the throttle breakpoint table in the file throttle.brk into a command map that is written to the file throttle.map. The file name throttle.map can then be specified in the control specifications file.

Notes:

Use the errs command to check for errors after using cmd_map_gen.

See Also:

Engine Controls, user_ctrl_specs, errs