other
Purpose:
-
Set target for ‘other’ control loop.
Enter:
-
other <target> [ramp_rate]
Where:
-
target
Specify the target value for the ‘other’ controller. Note: This may be the Throttle controller or the Dyno controller depending on which controller is controlling an ‘other’ channel.
ramp_rate
Optional. Specify the rate the ‘other’ target should be changed from its current value to the new target value.
Example:
-
other 150
The above command sets the ‘other’ target for the controller to 150.other 120 10
The above command sets the ‘other’ target for the controller to 120. The target will be ramped from its current value to the new target value at the rate of 10 [units]/sec.