u_mode
Purpose:
-
User Control Loop Mode
Enter:
-
u_mode <mode> <ctrler>
Where:
-
mode
The desired control loop mode. Specify one of the following modes:
- Open to place the control loop in the Open loop mode.
- Closed to place the control loop in the Closed loop mode.
ctrler
Specify the name of the controller to place in control mode = mode.
Example:
-
u_mode Open fuel_in_t
The above command places the controller fuel_in_t in the Open loop mode.u_mode Confused in_man_t
The above command places the controller in_man_t in the Closed loop mode. This is valid since the only character examined is the ‘C’ in the argument ‘Confused’.
Notes:
-
Only the 1st character of the ‘mode’ argument is examined to determine the mode.
Use the controller name that is specified in the control specs file under the keyword @USER_CTRL_LOOP. If the old ctrl_specs file format is being used, then the controller name is the name found on the line that contains the user control loop number.